1/2/02
ALA550
9
4
Button =
PANIC Function.
Button =
Channel 3 Function.
5
+
H7/8 Pink Wire
Channel 3 Output =
Momentary output
H7/8 Pink Wire
Channel 3 Output =
Latched output
H7/8 Pink Wire
Channel 3 Output =
Timer programming
(set to any interval
between 1 second
and 2 minutes.)
H7/8 Pink Wire =
Horn output
Channel 2 (3) Timer Control Output Programming.
Enter:
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 6 times and hold it until three chirps and a long chirp is hearing then release the
valet switch. You are now in the Alarm feature ‘III’ programming mode.
Timer Program:
1-a. Press and release the transmitter
button 3 times, [3] LED flash, [3] siren/horn chirp to indicate
your are in features “Channel 2 Timer Programming mode”.
1-b. Press and release the transmitter
+ button 3 times, [3] LED flash, [3] siren/horn chirp to
indicate your are in features “Channel 3 Timer Programming mode”.
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch. 1 long chirp for confirmation.
(Set any interval between 1 second and 2 minutes)
Note 1:
If your built-in timer control window/sunroof closure in your car DO NOT change the timer setting! This
requires installer-only programming. Changing the value will adversely effect operation and may cause
damage.
ALARM FEATURE “
IV” PRORAMMING:
1 Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 8 times and hold it until four chirps and a long chirp is hearing then release the
valet switch. You are now in the Alarm feature ‘IV’ programming mode.
3 Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
1
Exit the programming mode. (3 long chirp to confirm this exit.)
2.
Press & hold button for 4
seconds to delete the sensor
code
Wireless door / window
sensor & PIR sensor
programming mode
3
Override Without Password
Pin Code
/
Press & hold
button for 4 seconds to delete
the Password pin code
Override With Password
Pin Code
/
Password pin
code programming
4
“TEST” Mode for Zone 2 Hood
& Zone 3 Door Pin Switch
“TEST” Mode for Zone 4 /
the Optional Sensor
connected to 4 pin plug.
“TEST” Mode for Zone 1 /
Wireless door/window
sensor & PIR sensor
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps to confirm exit.
Program The Wireless PIR Sensor or Wireless Door/Window Sensor.
This system has a very unique interfacing with optional sensor, to extend more protection, such as PIR
(IR-70S) sensor or Door/Window sensor. (DS-70S)
For example, in your garage you can put a PIR for protection. (A device to detect person's movement in a
protected area.) If system armed, a person walk through the detect area, the siren inside the car will
alarming to raise the attention to the owner.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales